Перевод: с английского на все языки

со всех языков на английский

Failure Analysis and Control System

См. также в других словарях:

  • Failure mode and effects analysis — A failure modes and effects analysis (FMEA) is a procedure for analysis of potential failure modes within a system for classification by severity or determination of the effect of failures on the system. It is widely used in manufacturing… …   Wikipedia

  • Failure Mode and Effects Analysis — FMEA (Failure Mode and Effects Analysis oder auch deutsch: Fehlermöglichkeits und Einflussanalyse oder kurz Auswirkungsanalyse) sowie FMECA (Failure Mode and Effects and Criticality Analysis) sind analytische Methoden der Zuverlässigkeitstechnik …   Deutsch Wikipedia

  • control system — Means by which a set of variable quantities is held constant or caused to vary in a prescribed way. Control systems are intimately related to the concept of automation but have an ancient history. Roman engineers maintained water levels in… …   Universalium

  • Picture archiving and communication system — An image as stored on a picture archiving and communication system (PACS) The same image following contrast adjustment, sha …   Wikipedia

  • Hazard Analysis and Critical Control Points — (HACCP) is a systematic preventive approach to food safety and pharmaceutical safety that addresses physical, chemical, and biological hazards as a means of prevention rather than finished product inspection. HACCP is used in the food industry to …   Wikipedia

  • System safety — The system safety concept calls for a risk management strategy based on identification, analysis of hazards and application of remedial controls using a systems based approach.cite book|title= System Safety Engineering and… …   Wikipedia

  • Failure rate — is the frequency with which an engineered system or component fails, expressed for example in failures per hour. It is often denoted by the Greek letter λ (lambda) and is important in reliability engineering. The failure rate of a system usually… …   Wikipedia

  • Control chart — One of the Seven Basic Tools of Quality First described by Walter A. Shewhart …   Wikipedia

  • Control reconfiguration — is an active approach in control theory to achieve fault tolerant control for dynamic systems [1]. It is used when severe faults, such as actuator or sensor outages, cause a break up of the control loop, which must be restructured to prevent… …   Wikipedia

  • Control-Feedback-Abort Loop — Too often systems fail, sometimes leading to significant loss of life, fortunes and confidence in the provider of a product or service. It was determined that a simple and useful tool was needed to help in the analysis of interactions of groups… …   Wikipedia

  • Control (management) — Controlling is one of the managerial functions like planning, organizing, staffing and directing. It is an important function because it helps to check the errors and to take the corrective action so that deviation from standards are minimized… …   Wikipedia

Поделиться ссылкой на выделенное

Прямая ссылка:
Нажмите правой клавишей мыши и выберите «Копировать ссылку»